Ag Leader Intellislope Ver.5.2 Operation Manual - Manual (Page 31)

27
A
UTO
T
ILE
The plow has been lowered to 32 in,
which will allow installing at the desired
depth.
Auto Level: Automatically levels the
cutting edge of the plow as it is lowered
to its starting position (pitch plow).
If the machine is not configured as a pitch
plow, the “Up” and “Down” buttons are
used to manually adjust the position of
the machine's cutting edge.
Note that the plow depth indicated on the
screen is relative to the elevation of the
nearest surveyed point, which is not
necessarily the same as the depth in the
hole, since the surveyed path may have
ended some distance from the starting
hole.
When the plow has been into the hole, press the “Start Install” button to be ready to start installing.
WARNING: When pushing AutoLevel make sure people are clear, as the machine will move.
A
UTO
T
ILE IN
P
ROCESS
As installation progresses, the progress
is marked by a shaded region under the
target profile.
If the plow starts substantially below the
target depth, the target profile will initially
rise at an aggressive pitch to reach its
target depth, and then level out.