Ag Leader Intellislope CAN Simulator Operation - Manual

Operating the One System USB-to-CAN Adapter
with Intellislope
The Systec USB-CAN driver has a network driver option that allows multiple applications to use
the same hardware connection. To obtain this functionality you need to upgrade to or install
the newest USB-CAN driver that is recommended for use by Ag Leader and have a new style
USB to CAN adapter (PN 3204001). The old style adapter does not have the functionality
required for multiple applications.
New Style USB to CAN Adapter
1. Ensure the Tiling feature is unlocked and that the Integra is on current firmware
2. Create a tiling configuration and use these vehicle measurements:
a. Implement Offsets: Tile Plow Configuration
i. Antenna Location From Hitch Point: 120in
ii. Antenna Height From Ground: 137in
iii. Antenna to Plow Base: 127in
iv. Tip Location from Antenna (Horizontal): 24in in front
v. Antenna Location From Centerline: 0
Steps to upgrade laptop to use
1. Uninstall old GPS simulator & CAN Simulator
2. Install
the newest recommended Systec USB-CAN driver
a. You will be forced to uninstall the old one first
3. Plug in Systec USB-CAN module and go through the “found new hardware wizard.”
a. You may have to re-boot after
b. You may have to repeat the install process if the steps outlined do not work
4. Once the newest driver is installed, connect the USB-CAN hardware and start the USB-CAN
modul Control application. For default installations launch it from:
a. Windows Start Button -> All Programs -> USB-CAN modul Utilities -> Tools -> USB-CAN
modul Control (pictured below)
Page 1 of 5