AirSep MN179-1 B - Manual (Page 39)

MN179-1 _ 02/14 AirSep Corp. - FreeStyle 5 Service Manual Rev B
Figure 5.26
Figure 5.28
Figure 5.27
5. Remove the plugs from the top and bottom of the new adsorbent beds.
6. Place a 1.5 mm CS X 6 mm ID o-ring on the bottom cap of the adsorbent
bed cap.
7. Place a 1.5 mm CS X 3.5 mm ID o-ring on the top cap of the adsorbent
beds.
8. Align product manifold with the outlet on the new adsorbent beds and
gently push down until the o-rings are completely seated.
9. Place center bolt through product manifold and tighten to 15 in-lbs.
10. Reassemble FreeStyle 5, and leak test at bed connections