EOTech LWTS Light Weapon Thermal Sight - Manual (Page 36)

2-18
2.15 STARTUP PROCEDURES (Continued)
4. Exit the Main Menu and select AGC ON or AGC OFF as
described in section 2.11, as desired.
5. If desired, adjust the thermal brightness setting as
described in section 2.9.
6. If desired, adjust the gain setting as described in
section 2.10.
7. Select the desired polarity setting as described in
section 2.13.
8. While looking through the eyepiece at an object at least
45m away, rotate the objective focus ring until the best
(sharpest) thermal image is obtained.
2.16 SHUTDOWN PROCEDURES
1. Press and hold the ON/OFF/STANDBY button. The
device will shut down in approximately 4 seconds after
the STANDBY?, STANDBY!, and POWER OFF
messages appear sequentially in the eyepiece display.
Release the button when the eyepiece display turns dark.
2. Install the objective lens cover over the objective lens.
3. Remove battery pack; place battery pack and the LWTS
in the soft carrying case.
2.17 I/O JACK
With optionally available cables and equipment, the LWTS is
capable of receiving external power, exporting RS-170 data
to an external monitor or viewer, and importing RS-170 data
from a compatible device, via the I/O jack.