ididit Universal Steering Column: Old School Straight Horn Kit - Manual (Page 4)

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
10. Once you have all the horn kit components in position on the shaft
you can begin to reassemble the column. Slide the column tube
over the shaft and install lower bearing, wavy washer & locking
collar per column instructions.
11. Install the horn plunger into the tube by pushing the spring loaded
plunger into the larger hole, slide it into position by pulling it down
into the narrow end of the keyhole. The pressure of the spring,
along with gravity will hold the horn plunger in place.
12. Connect the horn plunger wire to the negative side of the horn relay
or simply follow the directions in your wiring kit.
Need Further Assistance?
ididit, inc has been serving the rodding community for over 25 years and we
take pride in our outstanding customer service. If you need further assistance,
feel free to call us at (517)424-0577, Monday-Friday from 8:30 am - 5:30 pm
and Saturday 10:00 am - 2 pm EST. You can also email us at tech@ididitinc.
com.
No part of this guide may be reprinted, reproduced or utilized in
any form without the express written permission of ididit, inc.
2012 ididit, inc.
All Rights Reserved
Printed in the USA
ididit,
inc.
610 S. Maumee St., Tecumseh, MI 49286
(517) 424-0577 • (517) 424-7293 fax
www.ididitinc.com