ididit Retrofit Steering Column: 1965-66 Ford Truck - Manual (Page 5)

3
Wiring
The ididit column has an OEM type turn signal
switch.
The harness has two connectors, one with 6 wires
and one with 2 wires.
If your wiring is still intact, you could use your
original plug. You would plug one wire at a time
(matching the original colors on both sides) into
the original terminal. Unfortunately, most of the
original plugs we were working with were cracked
or damaged. ididit has provided an extra set of
connectors and terminals with this column. You will have to plug each
wire terminal into these plugs before installation. Remember that these
wires have to match the color on the adjoining side.
Early
Vehicle Harness Function ididit Column Harness
Blue Turn Flasher Feed Blue
White/Blue Right Front Turn/Indicator White/Blue
Green/White Left Front Turn/Indicator Green/White
Yellow/Black Right Rear Turn/Brake Green/Orange
Green Left Rear Turn/Brake Orange/Blue
Red/Black Brake Feed Red/Black
Blue/Yellow Horn Ground Blue/Yellow
Rag joint installation
It is easier to install the rag-joint onto
the column before installing the column.
To install this joint, identify the 3/4DD
end and remove the setscrews and jam
nuts. Slip the joint over the shaft 7/8 of
an inch and install the setscrews into
the threaded holes. This should create
a witness mark where the set screws will
hit. Now remove the setscrews and the
joint. With a center punch, create a prick
mark so you can use a ¼ inch drill bit and create a relief for the setscrew.
This relief only needs to be approximately 3/16 inch deep.
Now install the rag-joint onto the column using locktite on the setscrews
and jam nuts.