ididit Right Hand Drive & Collapsible Steering Column: RHD Universal Tilt - Manual (Page 3)

How to install your Tilt, Turn Signal Levers and Hazard Knob
Turn Signal Lever:
The signal lever is the lever closest to the top
of the column. With the steering wheel and
adaptor removed, look down from the top
of the column and you’ll see where a single
screw holds the signal lever in place. Insert
the new lever using the provided screw into
round hole (not D shaped hole). When install-
ing this lever in a new column, use the screw
supplied to fasten the lever in the recessed
area on the signal switch arm.
Tilt Lever:
Look directly below the turn signal lever, and
you’ll see another opening in the column. Inside
this opening is a threaded hole which the new le-
ver screws into.
Emergency Flasher Knob:
Almost directly opposite the turn lever on the steer-
ing column is another opening. Inside this opening
is a hole in the nylon switch. Simply screw the
new knob in place (clockwise). When complet-
ing installation of flasher knob make sure that the
knob is in the out (off), position so when finished
wiring you don’t have any complications.
If Column Shift Application:
Place column shift knob onto the shift lever.
Once your lever is on, use setscrew (provided)
and adjust knob so set screw is not facing for-
ward, tighten setscrew. Do not remove the upper
shift lever for any reason! The tension spring
will pop out and it is very difficult to re-install.
2