ididit Steering Wheel Adaptor: 1955-68 Horn Kit w/Ring - Manual (Page 2)

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
1955-68 Horn Kit w/Ring Installation Instructions
for Most 55-68 GM Steering Wheels
For Part Number’s 2612100040
Instruction #: 8000010052 REV 10/13
Figure 9 Figure 10
6. Install the aluminum spacer ring provided in
the kit and silicone it to the back of the steering
wheel.
(Figure 8) Place a heavy object on top
of the ring in order to seal it to wheel. Allow
the silicone to dry fully before moving on to the
next step. If the ring doesn’t fit exactly right,
use a file or die grinder to trim the inside of
the ring. If it is way off due to a variation in
the wheel, please call us and we may be able
to make you something that will fit properly.
If this is the case, you may need to send your
wheel to our facility.
7. Next, install the wheel onto the column. If it
doesn’t want to go on at first, move the horn
cam with your thumb and index finger a little bit
one way or the other until the wheel drops down
fully into place. The horn cam is what cancels
the turn signals, so if your steering box is half
way between full left and right, and the road
wheels are pointed straight ahead, and the horn
cam is at the 10:30 position, the turn signals will
cancel correctly.
8. After the steering wheel is in place reassemble
the top half starting with the correct contact plate
size. Place the contact plate with the concave
side facing down then place the contact bushing
on top of the plate. Place the column nut on the
top shaft and tighten to approximately 35ft. lbs.
Next, place the horn ring in position and secure
it with the screw retainer. (refer to figures 2-4
and the diagram to the left for reassembly
order)
Note: make sure the barrels of the screw
retainer are pointing down. (Figure 9) Tighten
the three screws.
REASSEMBLY DIAGRAM
4. Horn Ring Retainer
(Screw Retainer)
3. Horn Ring
2. Contact Bushing
1. Horn Contact
Plate
(concave side down)
Down