ididit Steering Wheel Adaptor: Wheel Shoppe Banjo Wheel to ididit Column User Manual
ididit For the car
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Wheel Shoppe Banjo Wheel onto an ididit Column
Instruction #: 8000010011
REV 03/14
How to install...
1. Check to verify that your driving wheels are
straight. On the top of the column there is a tube
sticking out. This tube should be in the 10-12 O
Clock position when the wheels are straight.
2. Place contact plate in wheel and line up wire with
horn hole.
(Figure 1)
3. Put wheel onto adaptor and use 3 1/4”x28 Thread
button head screws to attach the wheel and contact
plate to the adaptor.
(Figure 2)
4. Place the wheel onto the column, lining up the
horn hole with the horn tube.
5. Install horn wire. To do this, push in and turn
clockwise.
(Figure 3)
6. Install 9/16-18 thread jam nut onto top shaft.
Torque to 35ft lbs.
(Figure 4)
7. Place spring in center of horn button and install
over nut.
(Figure 5)
8. Place ring over button and line up holes.
(Figure 6)
9. Using the three screws (10-24 socket cap screws),
install ring and tighten down.
(Figure 7)