ididit Floor Mount: Collapsible Floor Mount with Plate - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI PH: 517-424-0577 FAX: 517-424-7293
www.ididitinc.com
Collapsible Floor Mount
with Plate Installation Instructions
For Part Number’s 2401020010, 2402020010, 2401120010, 2401220010
Instruction #: 8000010251 REV 04/14
This floor mount is designed to mount a steering column to the floor
or firewall and can be installed on either side of the body. This mount
includes extra material used to repair any holes in the firewall left
behind by the existing steering column.
1. Choose the location of the mount. This should be a flat surface.
Note: The mount can be rotated in any direction. Cut out the
provided template and use it to help determine where the mount
will be located. Use a punch and mark the three locations
indicated with the X on the template.
(Instruction # 8000010498,
8000010499, 8000010500 or 8000010501)
2. Trim this piece as you see fit, keep in mind that the small plate
will be positioned against the large plate with the smooth side
down. Also note that if there are pedal interference issues, make
sure the bolt and nut do not end up in the way.
(Figure 1)
Note: If welding your new plate make sure to remove the O-Ring.
3. Once the plate is fitted inside your vehicle you can then start to
assemble the floor mount to the column. Slide the flanged plate
onto the bottom of the steering column tube with the flange facing
the top of the column. Next slide the O-Ring onto the column.
(Figure 2)
4. Install the column through the floor plate while retaining the order
of the floor mount pieces. (Figure 2)
5. Use the provided hardware to secure the floor mount to the floor.
Slide 1 flat washer and 1 lock washer on each of the bolts and
thread the bolts through the holes on the floor mount. These bolts
are to be torqued at 11 ft. lbs.
(Figure 3)
6. Your installation is now complete!
*PLEASE NOTE: The enclosed floor mount has a “hot dip” black oxide
finish. It would be important to put a permanent finish on it before you
install.