ididit Column Add-Ons: Optional Lever - Manual

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
ididit inc. 610 S. Maumee St. 49286 Tecumseh, MI • PH: 517-424-0577 • FAX: 517-424-7293 • ididitinc.com
Instruction #: 8000010103 REV 01/13
How to Install the Optional Lever on your Column
For Part #’s 3100020000, 3100010000, 3100030000, 3100040000, 3100050000, 3100060000
Your optional lever has been wired along with the rest
of the steering column. To eliminate damage during the
shipping process, the lever has not been installed to the
steering column.
1. Install the flat end of the lever through the upper hole so
that the lever angles toward the driver. (Figure 1)
2. Using the provided screw, install the screw through the
eyelet on the black wire, and then take the screw (with
eyelet attached) through the lever and into the round
hole
(Figure 2A) in the turn signal switch. (Figure 3)
3. You will need to tighten this screw very tight since it
will take a fair amount of abuse from use.
4. The installation of your optional lever is now complete.
(Figure 4)
Install the other knobs and levers as instructed on the sheet
attached to the dress up kit.