ididit Electrical: Ignition Switch Test - Manual (Page 4)

PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
PROPERTY OF
ididi
T, inc
4
ididit inc. 610 S. Maumee St. Tecumseh, MI 49286 517-424-0577 FAX: 517-424-7293 ididitinc.com
Check a relay
The dirty way to find out if the relay is working in the car.. does it click ?? Hold relay in
hand and turn the key.. you will feel and hear it when it connects. Use caution. As the
other relays are near this and you could hear other relays click at the same time.
OR
Remove relay from plug.
Get a 12 volt power supply..battery.. battery charger..
Provide ground to #85
Provide power to #30 and #86, #86 is the trigger wire and can be toggled
Check with a test light for power on terminal #87
If relay is good on bench test but not good when installed..Check wire terminal in plug.
Should be corresponding wire to terminal #30.
If wire has power, make sure the terminal wire is not pushing out the back of the plug
when relay is installed.
Our relays have a mounting tab. This tab is not needed, and not a ground.