ididit Cable Shift Linkage Kit: Ford Column to Ford C-4 Transmission - Manual (Page 2)

Before installation please read:
You will need at least 2” of clearance between the firewall and lower
shift lever for this product to function correctly. This transmission
uses all Metric fasteners.
Melted Cables: If your cable is too close to your exhaust it will melt or be-
come brittle. If this is the case you will need to make a heat shield. Do not
wrap the cable as this retains heat. Heat will destroy the cable.
Kinked Cables: Do not kink the cable anywhere along its length. If the cable
has a kink it will lock up. The cable should be kept straight for 2” on each end
where it leaves the brass. Either of the above could damage the cable, shifter,
and/or transmission in one shift.
Cable Adjustment: If you do not adjust the cable correctly you could dam-
age the cable, shifter and/or transmission. Put the trans in Low gear and the
shifter in Low gear, set the swivel so it slides in and out of the correct hole
freely. Then move the transmission and shifter to Park (all the way the other
way). Rotate the cable swivel until it slips in and out of the hole freely. Now
go back and forth between Park and Low gear and fine tune the adjustment.
See instructions for further detail.
A.) Pan Bracket
B.) Transmission Lever
C.) Transmission Lever Bolt & Nut
D.) Swivels
E.) Cotter Pin
F.) Shift Cable
G.) Two Piece Bracket
H.) Horseshoe Bracket
A.
C.
B.
D.
E.
F.
G.
H.
Your kit should contain the following parts:
1