ididit Cable Shift Linkage Kit: Chrysler Column to Chrysler 727&904 Transmission - Manual (Page 2)

Before installation please read:
You will need at least 2” of clearance between the firewall and low-
er shift lever for this product to function correctly.
Melted Cables: If your cable is too close to your exhaust it will melt or
become brittle. If this is the case you will need to make a heat shield. Do
not wrap the cable as this retains heat. Heat will destroy the cable.
Kinked Cables: Do not kink the cable anywhere along its length. If the
cable has a kink it will lock up. The cable should be kept straight for 2”
on each end where it leaves the bracket. Either of the above could damage
the cable, shifter, and/or transmission in one shift.
Your kit should contain the following parts:
A.) Transmission Lever
B.) Transmission Lever Bolt & Nut
C.) Spacers
D.) Cotter Pins
E.) Swivels
F.) Pan Bracket
G.) Shift Cable
H.) Two Piece Bracket
I.) Horseshoe Bracket
A.
C.
B.
D.
E.
F.
G.
H. I.
1