ididit Cable Shift Linkage Kit: Ford Column to Ford AOD Transmission - Manual (Page 8)

19. You will need to take the small nut and
the rubber boots off so that you can
get one large nut and washer off. Put
the cable through the bracket from the
bottom side of the bracket and reinstall
the large nut, washer, and boots. Try
to center the nuts and washers on the
available threads. This is important
later.
20. Push the cable down through its outer cover so that it will be as short
as possible. Put the column in Park. Now, figure out where you want
the bracket to be, 5 o’clock will probably be a good place. Install
the swivel on the small thread and turn it until it is centered on the
thread. Now, install the small nut and turn it until it bottoms out on
the swivel. DO NOT tighten yet.
21. Route the bracket until the swivel drops into the
5/16” single hole 2” from the center of the main
shaft. If the bracket hits something or is in a bad
place, you can use another set of holes in the
horseshoe bracket, move the swivel up or down
its thread length, or move the cable on its length
of threads. Install the cotter pin in the swivel.
Always remember that the cable that moves
must be pushed all the way. Tighten the bracket
onto the tube.
If you are having problems with your installation
please contact us at:
PH: (517) 424-0577 or email: [email protected]
M-F 8:30a-5:30p EST
Sat. 10:00a-2:00p
www.ididitinc.com
7