Innovate Motorsports LM-1 Quick Start Guide - Manual

LM-1 Accessories:
ƒ LMA-2: Auxiliary Input #2 (RPM converter): #3726
ƒ LMA-3: Auxiliary Input #3 (AuxBox- RPM, Temp,
Duty Cycle, Acceleration, Boost/MAP): #3742
ƒ Exhaust Clamp: #3728
ƒ Inductive Clamp: #3727
ƒ HBX-1: Heat-sinking Bung Extender: #3729
ƒ XD-1: Digital Display with Remote Record Control: #3743
ƒ Power Cable w/ battery Clips: #3734
Replacement Parts:
ƒ Analog Output Cable: #3730
ƒ Power Cable w/ Cigarette-lighter adapter: #3740
ƒ Bung/Plug set: #3735
ƒ Sensor (Bosch LSU4.2): #3737
ƒ Sensor Cable: #3738
ƒ Serial
Cable: #3741
Order parts, get support, find FAQ answers, and read case
studies at www.tuneyourengine.com
Warning!
1) The Oxygen Sensor used in this device gets very hot in
operation. Do not touch the hot sensor. Do not let a hot sensor
touch a combustible surface. Do not use the sensor with or near
flammable liquids or gases. Failure to heed these warnings may
result in severe burns, explosions or fires. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and
operating with the LM-1 whenever the car is running. An un-
powered oxygen sensor will be quickly damaged when exposed
to hot exhaust gases.
< (10-2303.B)
LM-1 QUICK START GUIDE
The complete instruction manual is on the CD
Warning!
1) The Oxygen Sensor used in this device gets very hot in operation. Do not touch the
hot sensor or let a hot sensor touch a combustible surface. 2) When installed in the
exhaust, the oxygen sensor MUST be connected and operating with the LM-1
whenever the car is running. An un-powered oxygen sensor will be quickly damaged.