Innovate Motorsports LC-2 User Manual

Innovate Motorsports Measuring instruments

Advertising
background image

11-0137

LC-2 Digital Air/Fuel Ratio (Lambda)

Sensor Controller Manual

Warning!

The Oxygen Sensor used in this device gets very hot in operation.
Do not touch the hot sensor. Do not let a hot sensor touch a combustible surface. Do
not use the sensor with or near flammable liquids or gases. Failure to heed these
warnings may result in severe burns, explosions or fires.

When installed in the exhaust, the oxygen sensor MUST be connected and operating with
the LC-2 whenever the car is running. An un-powered oxygen sensor will be quickly
damaged when exposed to hot exhaust gases.


1

LC-2.......................................................................................................... 2

2

Mounting and Wiring the LC-2 ................................................................. 3

2.1

Mounting............................................................................................. 3

2.2

Wiring ................................................................................................. 3

2.2.1

Single Innovate Device Relay Wiring Instructions..................... 5

3

Sensor Placement.................................................................................... 5

4

Sensor Calibration.................................................................................... 6

4.1

Calibration Schedule .......................................................................... 7

5

Software (LogWorks 3 and LM Programmer) .......................................... 8

5.1

Download the Logworks 3 software package .................................... 8

5.2

Installing software............................................................................... 8

5.3

Connecting to LM Programmer .......................................................... 8

5.3.1

Analog Outputs .......................................................................... 9

5.3.2

Advanced output programming ............................................... 10

5.3.3

Updating the Firmware ............................................................ 11

5.4

Logging data from your LC-2 with LogWorks................................... 11

6

LC-2 Error Codes and Troubleshooting Tips ......................................... 12



Advertising