Innovate Motorsports LC-1 Quick Start Guide - Manual

LC-1 Accessories:
ƒ LMA-3: Auxiliary Input #3 (AuxBox- RPM, Temp,
Duty Cycle, Acceleration, Boost/MAP): #3742
ƒ DL-32 (32 Channel Vehicle Mounted Data-Logging System)
#3782
ƒ XD-16 (Air/Fuel Digital Gauge) #3780
ƒ Exhaust Clamp: #3728
ƒ Stainless Steel Bung w/ Steel Plug” #3736
ƒ HBX-1: Heat-sinking Bung Extender: #3729
Replacement Parts:
ƒ Terminator Plug: #3750
ƒ MTS 2.5mm to 2.5mm serial cable: #3760
ƒ Bung/Plug set: #3735
ƒ Sensor (Bosch LSU4.2): #3737
ƒ Serial Programming Cable: #3746
Order parts, get support, find FAQ answers, and read case
studies at www.tuneyourengine.com
Warning!
1) The Oxygen Sensor used with this device gets very hot in
operation. Do not touch the hot sensor. Do not let a hot sensor
touch a combustible surface. Do not use the sensor with or near
flammable liquids or gases. Failure to heed these warnings may
result in severe burns, explosions or fires. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and
operating with the LC-1 whenever the car is running. An un-
powered oxygen sensor will be quickly damaged when exposed
to hot exhaust gases.
< (10-2303.B)
LC-1 (Lambda Cable)
QUICK START GUIDE
The complete instruction manual is on the CD
Warning!
1) The Oxygen Sensor used with this device gets very hot in operation. Do not touch
the hot sensor or let a hot sensor touch a combustible surface. 2) When installed in
the exhaust, the oxygen sensor MUST be connected and operating with the LC-1
whenever the car is running. An un-powered oxygen sensor will be quickly damaged.