Installation instructions, Complete installation - continued – JELD-WEN JII015 Vinyl Patio Doors without Nailing Fin User Manual
Page 9
INSTALLATION INSTRUCTIONS
for Vinyl Patio Doors without Nailing Fin (JII015)
9
Please visit jeld-wen.com for warranty
and care and maintenance information.
Thank you for choosing
©2014 JELD-WEN, inc.; This publication and its contents are owned by JELD-WEN, inc. and are protected under the U.S. Copyright Act and other intellectual
property laws. All trademarks, service marks, logos and the like (whether registered or unregistered) are owned or controlled by JELD-WEN, inc. or others.
Unauthorized use or duplication of JELD-WEN intellectual property is prohibited.
JELD-WEN reserves the right to change product specifications without notice. Please check our website, jeld-wen.com, for current information.
(08/14)
COMPLETE INSTALLATION - CONTINUED
7
FINISH INSTALLATION
• Drive two
#10 x 2 1/2" screws
(included in hardware
pack) through the
open screw holes in
the strike plate.
• Remove the pre-
installed screws from
the strike plate and
replace them with
the remaining
#10 x 2 1/2" screws
from the hardware
pack. This will
increase security by
attaching the patio
door to the structure.
CONTINUOUS AIR SEAL
Create a continuous air seal on the interior between the rough opening
and the door frame with backer rod and sealant or low expansion foam.
Allow the foam to fully cure and cut flush with a sharp knife. Make sure
the foam cuts cleanly and doesn’t tear.
AFTER INSTALLATION
1. Cover the screw holes
in the frame with the
provided vinyl caps.
2. Seal any gaps or
openings at end of
horizontal mull joints
with sealant.
3. For flush fin doors,
apply sealant on
the exterior where
the flush fin meets
the wall. For finless
doors, seal the gap
between the door
frame and rough
opening (or as wall
detail dictates)
with backer rod
and sealant.
4. Install exterior wall
surface (if applicable)
per manufactures’
guidelines.
5. Protect recently
installed units
from damage from
plaster, paint, etc.
by covering the unit
with plastic.
6. Remove labels or other materials adhered to glass within 30 days
after installation.
Premium Patio Door
Replacement screw
Pre-installed screw
Pre-installed screw
Builders Patio Door
Pre-installed screw
Replacement screw
Pre-installed screw
Backer rod
Gap
Rough
opening
Door
frame
Sealant joint
Gap