Nitrous Express DIESEL STACKER NITROUS NXD12000 - Manual

NXD11110, NXD12000
DIESEL STACKER NITROUS INSTALLATION INSTRUCTIONS
Congratulations on the purchase of your Nitrous Express Diesel Nitrous System. This system does not
add fuel and is intended to be used with an engine management system that can add nitrous enrichment fuel
through the engines injectors
Nitrous Express utilizes only the highest quality components designed for the
use of liquid nitrous oxide. To properly utilize these specially designed components and obtain the trouble-
free operation that this system is capable of producing, it is extremely important that you read all
instructions carefully. Pay special attention to the important notes at the end of the installation steps and the
tuning tips listed at the back of this instruction sheet.
To insure proper system assembly and operation, carefully read the following installation procedures
thoroughly before beginning. Use NX thread sealer on all pipe thread connections, DO NOT use any sealer on
flare connections, hose, or bottle connections. Use no other sealing compounds or Teflon tape. All threads
must be clean and dry, apply only enough sealer to wet the threads, too little is better than too much.
Excessive tightening of parts is not necessary, snug is enough. If it is necessary to remove a fitting installed
with the red NX sealer heat must be applied to release the sealing agent. NOTE: Due to shipping restrictions
all NX nitrous bottles arrive empty. Before beginning the installation the N2O bottle should be filled by a
NX accredited filling station.
Before starting any installation procedures care- fully disconnect the vehicle negative battery cable. If
there is any question about this operation, consult the vehicle owner’s manual!
MOUNTING THE BOTTLE
Slide bottle into bottle brackets. Use illustration (A) as a guide for proper alignment. Locate bottle
assembly in a mounting area that will provide easy access to bottle valve, for hose connection and bottle
removal. Using the bottle unit as a pattern, mark and drill four 3/8” holes. Note: Before drilling holes be
sure to check beneath the area being drilled for obstructions, fuel lines or fuel tank. Then secure unit to
mounting surface. (Recommend minimum of four 5/16” grade five bolts). Align bottle in brackets so that
the valve outlet is pointing down- ward to the mounting surface (See Illustration A) and tighten the bottle
bracket bolts. NOTE: This is VERY IMPORTANT so that the internal siphon tube will pick up liquid
nitrous.
ILLUSTRATION A