Nitrous Express REMOTE BOTTLE OPENER (11107 ) - Manual

REMOTE BOTTLE OPENER
PN 11107
Congratulations on purchasing the worlds’ first and
finest remote bottle opener. This opener will allow
you to stay in the comfort of your seat and open your
nitrous bottle. Nitrous Express has designed the
opener to work with NX bottles, but may be adapted
to fit all other bottles valves.
The motor has been installed on the main body
for your convenience. The motor can be rotated to 4
different positions if clearance is needed.
1. Remove the bottle from the vehicle, leaving the
nut and nipple intact.. Install the furnished D-4
cap onto the nipple. Open the valve completely
(Do not over open the valve). This will give the
proper installation height for the opener to work
without binding. (See Illustration A)
2. Remove plastic cap on handwheel. Using a ½
wrench remove the hand wheel from the top of the
bottle valve.
3. Install the adaptor collar around the top of the
bottle valve just below the hand wheel. (See
Illustration B.) Now tighten allen bolt on collar to
secure it to the valve.
4. Install the valve opener gear over the square brass
stem on the top of valve. (See Illustration B)
5. Install the nut from the original handwhel onto the
opener gear. The opener gear now serves a dual
purpose, becoming a handwheel when the body is
removed to assist in filling the nitrous bottle.
6. Install the main body over valve and collar
making sure the gear on the drive motor meshes
with the bottle gear correctly and the hole for
the thubscrew is properly aligned. NOTE: IF
THE GEARS DO NOT MESH CORRECTLY,
THE MAIN BODY WILL NOT SET DOWN
PROPERLY AND DAMAGE TO THE DRIVE
MOTOR TRANSMISSION IS POSSIBLE
7. Once the main body is installed correctly, tighten
the thumbscrew securely (HAND TIGHT!). (See
Illustration C)
8. Wiring your system. (See Illustration D) Cut the red
and black wires 10 inches from the motor. Install
ILLUSTRATION A
ILLUSTRATION B
ILLUSTRATION C