Nitrous Express REMOTE BOTTLE OPENER (11107 ) User Manual
Page 2
the seals and male weather pack terminals on the motor side wires. The wires going to the activation switch will use
female terminal ends. Slide the terminals into the weather pack housings. NOTE: CARE MUST BE TAKEN TO
INSTALL THE TERMINALS WITH THE CORRECT WEAHTER PACK HOUSING. IMPROPER
INSTALLATION WILL NOT ALLOW THE TWO HALFS TO PUSH TOGETHER.
9. Run the remaining red and black wire to the opener switch mounting location. Follow the switch socket diagram
for proper location of these wires.
10.
Using 14 gauge red wire, connect the + from battery terminal of the opener switch to an ignition switch controlled 12-
volt positive source. Using 14 gauge black wire, connect the - from battery terminal of the opener switch to ground.
(See Illustration E.)
11. The switch has an internal light for easy location a night. This lighting terminal will connect to an interior lighting wire
for proper dimming function to work. To locate this power source consult a wiring manual for your vehicle.
(See Illustration E.)
12. Now to complete the installation reinstall the bottle, and plug the weather pack connectors together. Turn the
vehicle on and press the close side of the opener control switch for 2 seconds and the opener should completely
close the bottle valve. Slowly remove the D-4 cap on the bottle nipple. WARNING NITROUS HAS EXTREMELY
COLD PROPERTIES! FROST BITE MAY OCCUR IF CONTACT WITH THE SKIN! A small amount of nitrous
will escape, if the valve is leaking reinstall the cap and cycle the opener open and closed and recheck for leaks. If the
opener does not completely close the valve a clutch adjustment may be necessary.
NOTE: Units produced after 1/12/12, feature an electronic cutoff and no longer require clutch adjustments.
13. To set the clutch adjustment you must first remove the motor from the opener body. Illustration F shows the allen
screws that must be romoved in order for the body and the motor to be separated. See the Illustration G below for
proper clutch adjustment. When tightening or loosening the clutch, make 1/4 turn and test on the bottle valve. After
the valve has been verified not to leak reinstall the supply line. The installation is now complete and the remote
opener is ready to use.
Black Wire To Motor
ILLUSTRATION D
From Battery
From Battery
From Battery
Red To Motor
ILLUSTRATION E
Tighten
Clutch
Loosen
Clutch
ILLUSTRATION F
ILLUSTRATION G