Nitrous Express Purge Valve system (15605 ) - Manual

Purge Valve system part number 15605
The installation of this purge valve will add to the value, consistency, and performance of your NX
system. The purpose of the purge is to remove all gaseous nitrous and air from your main feed line. This
puts liquid nitrous at the N2O solenoid resulting in a harder leave or “hit”.
Before you begin make sure that your bottle valve is closed and your main feed line is empty. Liquid
nitrous can cause severe frostbite if it comes in contact with your skin! Use NX liquid thread sealer on
any NPT fittings. Never use Teflon tape on any fittings of a nitrous system. AN fittings do not require
sealer of any kind.
Section A – Installation with N2O plates with integrated solenoids
1. Using the supplied T fitting, connect the inlet of the purge solenoid to the 1/8NPT side of the T
fitting.
2. Plug the Purge port of the purge solenoid with the supplied Allen Head Pipe plug
3. Connect the 1/8NPT to 3/16 compression fitting into the N2O out port on the purge solenoid.
4. Insert the 3/16 hard line into the compression fitting and tighten the compression nut.
5. Bend the 3/16 hardline in a direction that will route the purged nitrous out of the engine
compartment. The preferred is venting is at the windshield base so the nitrous flow can be
viewed from the driver’s seat.
6. Connect the supplied high output 3an line between the T fitting and the plate.
7. Connect the other side of the T fitting to the nitrous feedline