Rocky Mountain Radar KAT-TRAXX - Manual (Page 10)

BUTTON OPERATION FOR ACCELERATION MODES
�MODE BUTTON
Press MODE button for three (3) seconds to go COMBO or
ACCELEROMETER mode.
Press MODE button to select Radar Detector mode or G Force
mode or 0-60 Mile mode or 1/4 Mile mode in COMBO mode.
Press MODE button to select G Force mode or 0-60 Mile mode
or 1/4 Mile mode in ACCELEROMETER mode.
�START BUTTON
Press START button at each mode for internal calibration.
�MEMORY BUTTON
At the end of 0 TO 60 MILE (0 to 100Km) and 1/4 MILE (400m)
measurement, press the MEMORY button until the desired
memory location, MEMORY#1~MEMORY#5 shows in the
display. Then press START button to store the new
measurement information. The measurements are stored in
memory.
Press the MEMORY button to check stored measurement at
the MEMORY#1~#5, which it toggles from MEMORY#1 to #5
by pressing the MEMORY button, at any time except Radar
Detector mode and a measurement is not running. Press the
UP and DOWN button to scroll the measurement data. Press
START or MODE button to exit the MEMORY mode.
Press MEMORY button for three (3) seconds to enter set-up.
�UP AND DOWN BUTTONS
Press UP or DOWN buttons to review data from the MEMORY.
SAFETY ALARM MODE OPERATION
You can set safety level of lateral G-force. Hold down
MEMORY button and turn on the Power to set up Safety Alarm
mode.
a. The TRAXX displays safety mode on/off: ‘SA ON’ or ‘SA
OFF’
b. Select ‘SA ON’ or ‘SA OFF’ by using UP/DOWN buttons.
When voice mode is off, ‘On’ gives “one beep” and ‘Off’
gives “two beeps” .
c. Press Memory button to set ‘On’ or ‘Off’. If you select
‘Off’ by pressing Memory button, the unit exits the safety
alarm mode.
If you select ‘On’ by pressing Memory, it displays Safety
Alarm Level. Press ‘UP/DOWN’ button to adjust the G-
force level. Long button press makes fast level
adjustment. Press Memory button to exit this mode.
d. Factory default is Safety Alarm ‘On’ and level is ‘0.6G’.
The level can be set minimum 0.2G to maximum 2.0G.
Safety alarm ‘On’/’Off’ and level are stored in the
memory.
TRAXX gives warning sound and visual blinking if your vehicle
exceeds level during a right or left turn.
19
TRAXX
OWNER’S MANUAL
18
TRAXX
OWNER’S MANUAL
S A O N S A O F F
S A 0 . 6