Rocky Mountain Radar KAT-TRAXX - Manual (Page 4)

CONTROL AND BUTTONS
a. Power on/off and Volume Control
b. DC 12V Power Input Jack
c. Start Button/ Backlit Button
d. Down Button/ Voice on/off Button
e. Mode Button
f. Memory Button/ Mute Button
g. Up Button/ City Button
h. Display
i. Front Laser Detection Lens
j. Radar Antenna
k. Rear Laser Detection Lens
INSTALLATION
For the best performance of acceleration features, mount
TRAXX on the windshield centered between driver and
passenger. TRAXX must be positioned straight across the
vehicle. Do not angle the device toward the driver. The front of
the device does not have to be perfectly level. This device
automatically compensates for mounting angles up to 30
degrees from level.
Adjust the device on its windshield bracket until it is
approximately level. It is important that the device stays in
position during use. If the device moves too easily, attach
suction cups firmly.
For the best performance of radar detector feature, select the
proper location for the device where it has a direct view of the
road. The radar antenna and laser lens are located behind the
rear panel of the device. The antenna and lens should not be
obstructed by metal or metallic surface and should be pointed
at the horizon for accurate long range detection.
∙ Choose a location that does not block the driver’s vision.
∙ Mount the device in a level position.
∙ Do not mount the device behind metal surfaces, windshield
antenna, wiper blades, ornaments or mirrored glass.
∙ Headed windshields, currently available as an option on
some Ford or GM vehicles act as an impenetrable barrier to
radar signals.
∙ Do not mount the device where the driver or passenger
might collide in the case of an abrupt halt.
Note: Whichever mounting method you choose, remember to
place the device out of view when you leave your vehicle. This
keeps the device out of sight from thieves and prevents exposure
to extremely high temperatures. 7
TRAXX
OWNER’S MANUAL
6
TRAXX
OWNER’S MANUAL