Rocky Mountain Radar KAT-TRAXX - Manual (Page 5)

Caution: On some newer model cars, a plastic safety coating
has been applied to the windshield. The suction cups may leave
permanent marks on the windshield once they are removed.
Check your vehicle owner’s manual to see if your car has the
plastic safety coating.
�Windshield Mounting
1. Attach bracket to windshield
2. Bend bracket for correct detection angle
3. Plug power cord into the device
4. Attach bracket to device
5. Plug power cord into cigarette lighter
�Dashboard Mounting
1. Peel protective paper off one side of hook-loop
2. Tape on device’s bottom
3. Peel top paper off
4. Place device on dash board
5. Plug power cord into the device and cigarette lighter
�Power and Volume Control
The TRAXX is designed to operate on most DC12V negative
ground vehicle electrical system. The power cord provided with
the device has a cigarette light socket plug at one end and a
small connector at the other.
To turn on the TRAXX, connect power and rotate the wheel
controller, located on the side of the device, until you hear it
click. To turn it off, rotate the wheel controller in the opposite
direction. You can control volume level with this wheel.
9
TRAXX
OWNER’S MANUAL
8
TRAXX
OWNER’S MANUAL