Rocky Mountain Radar KAT-TRAXX - Manual (Page 6)

HOW DOES IT WORK?
The TRAXX measures the performance of your vehicle by
sensing acceleration forces. It uses a three-axis accelerometer
to measure acceleration. This digital three-axis accelerometer
sensor tracks your vehicle’s acceleration and cornering forces.
This device analyzes data and calculates corrected G-Forces
for the G Meter operation, speed and distance data. The result
is the most accurate.
The TRAXX provides distinct visual and voice alerts to warn
you of the presence of X, K and all kinds of Ka band radar guns
in the front and rear of you. This model also provides the
benefit of ‘undetectability’ by alerting you to the presence of
VG-2 (Radar detector-detector). The unit also scrambles all
laser devices.
The TRAXX has Safety alarm mode for safe driving. You can
set safety level of lateral G-force. TRAXX gives warning sound
and visual blinking whenever you exceed your level setting.
WHAT CAN IT MEASURE AND DETECT?
�TRAXX can measure the followings:
1. Time to go from 0 to 60MPH (0 to 100Km)
2. Speed at the end of 1/4 mile (400m)
3. G-Force
4. Peak and Average Horsepower
�TRAXX can detect the followings:
1. X, K and Superwide Ka band radar guns
2. Laser guns (Laser speed monitoring devices)
3. VG-2 undetectability
4. Laser Scrambler
SET-UP
If this is the first time the device is powered since installation or
if the orientation has changed, please move the vehicle to a
level place and calibrate the three-axis accelerometer. Press
Mode button to go G-FORCE mode and complete calibration
by pressing START button.
To accurately measure horsepower, the correct vehicle weight
and the correction factor for the vehicle must also be entered to
allow a horsepower calculation. To enter set-up mode, press
MEMORY button for three (3) seconds at any mode of G-
FORCE / 0 TO 60/ 1/4mile except Radar Detector mode until
default weight of 2000lbs shows in the display. Please enter
your vehicle weight and each correction factors.
�SET-UP FOR METRIC USE
You can set up your TRAXX for US or Metric unit and calculate
engine power in HP or PS (metric horsepower). When pressing
‘DOWN’ button and turn on the Power at the same time, it
displays current engaged mode. Press UP/DOWN button to
toggle ‘US’ or ‘METRIC’ and press ‘MEMORY’ button to select.
The factory default is ‘US’. Please enter its metric calculation
factor. When ‘US’ or ‘METRIC’ is changed each other, its
measurement will be changed as follows.
- US: Time to go from 0 to 60MPH / METRIC: 0 to 100Km
- US: Speed at the end of 1/4 mile / METRIC: 400m
11
TRAXX
OWNER’S MANUAL
10
TRAXX
OWNER’S MANUAL
SET-UP ITEM MIN MAX DEFAULT STEP
VEHICLE WEIGHT (LBS) 25 16000 2000 5
HP FACTOR 1.00 2.00 1.00 0.01
HP MIN SPEED (MPH) 10 60 30 1
HP MAX SPEED (MPH) 30 100 50 1