Rocky Mountain Radar KAT-TRAXX - Manual (Page 8)

The maximum of the HP MIN Speed cannot exceed the
minimum of the HP MAX speed.
The device enters G-Force mode after setup and the display
shows the current G-Force reading. G-Force can be zeroed at
any time by pressing START button.
ACCELERATION MODE OPERATION
TRAXX has two operation modes, which are COMBO and
ACCELEROMETER.
Combo mode: There are four(4) operations in Combo mode.
Press Mode button to select Radar Detector mode or G Force
mode or 0-60 Mile mode or 1/4 Mile mode.
If the TRAXX receives Radar or Laser signal when it is in
accelerometer operation, it stops measurement and gives
Radar or Laser warning. We recommend you to select Radar
Detector mode while driving.
Accelerometer mode: There are three(3) operations in
Accelerometer mode. Press mode button to select G-Force
mode or 0-60 Mile mode or 1/4 Mile mode. Radar-Laser
detection is not active in Accelerometer mode. We recommend
you to enter Accelerometer mode when you measure
acceleration.
The factory default is Radar Detector mode in Combo.
Press Mode button for three(3) seconds to change the mode
between COMBO and ACCELEROMETER.
�CALIBRATION
Calibration is performed automatically when you press START
button at G-FORCE mode.
�0 to 60 MILE MODE / 0 to 100KM MODE
Your vehicle must be stopped before you perform any
measurement. Pressing start Button to perform an internal
calibration. After the calibration is completed successfully, its
display shows 'READY' with blinking:
The measurement begins as soon as the vehicle starts moving
and the display shows the elapsed time until 60 MPH (100km)
is reached. Then it shows the time to reach 60 MPH (100km).
15
TRAXX
OWNER’S MANUAL
14
TRAXX
OWNER’S MANUAL
COMBO ACCELEROMETER
RADAR DETECTOR MODE
G-FORCE MODE
G-FORCE MODE
0 TO 60 MILE / 0 TO 100Km 0 TO 60 MILE / 0 TO 100Km
1/4 MILE / 400 METER 1/4 MILE / 400 METER
- . 0 0 � . 0 0
R E A D Y
4 . 7 5 s e c