Rocky Mountain Radar KAT-TRAXX User Manual
Page 12
�TEST MODE
Hold down UP button for three seconds, the TRAXX will
demonstrate how it operates when each radar and laser signal
is detected.
X Band signal detected operation
K Band signal detected operation
Ka Band signal detected operation
Laser signal detected operation
VG-2 signal detected operation
TROUBLESHOOTING
If the device does not turn on:
1. Check the power cord. Be sure all power connectors are
properly installed.
2. Check the fuse that controls power to the cigarette
lighter socket. See your vehicles owner's manual
3. The cigarette lighter socket might be dirty. Clean it with
fine emery cloth to ensure a good and clean connection.
4. Vehicle electrical problem exists.
5. Make sure that the volume control is in the ON position.
Caution : Do not place any metal object other than the cigarette
lighter or a cigarette lighter plug in the cigarette lighter socket.
If the device gives a false Radar/Laser alert when
the vehicle hits or bumps:
1. Check the vehicle's electrical system, including main
battery cable and alternator connections.
2. Install a filter capacitor(470uF. 25volts) on the back of
the cigarette lighter socket, across the power
connections.
If the receiving Radar/Laser signals are weak:
1. Check the angle of device.
2. Point device to the horizon.
3. Radar antenna / laser sensor is obstructed.
4. Relocate the device.
23
TRAXX
OWNER’S MANUAL
22
TRAXX
OWNER’S MANUAL
X
▶
X
▶ ▶
X
▶ ▶ ▶ ▶ ▶ ▶
K
▶
K
▶ ▶
K
▶
▶ ▶
▶ ▶
▶ ▶
▶ ▶
▶ ▶
▶
Ka
▶
▶
Ka
▶
▶▶
▶
Ka
▶
▶▶
▶▶
▶▶
▶▶
▶▶
▶
L A S E R
V G - 2