SIGMA ROX 10.0 GPS - Manual (Page 10)

page 10
Attaching the bracket
Attaching the RoX 10.0 gps and initial use
www.sigmasport.com ROX 10.0
ROX 10.0
2 Attaching the ROX 10.0 GPS and initial use
2.1 Attaching the bracket
− Attachment to the handlebars or stem.
− Remove the yellow foil.
− The bracket can be attached using either cable ties (permanent attachment)
or the o-rings.
Detailed attachment information can be found in the quick start guide provided.
2.2 Before initial use
Note
Fully charge the RoX 10.0 gps:
Charge the device using the micro Usb cable and the Usb port on your pC.
Alternatively, use the Usb charger supplied. The process takes approximately
three hours.
To charge the device, plug the Usb cable into the micro Usb port on the back
of the RoX 10.0 gps and the Usb port on your pC or the Usb charger. only
charge the battery at an ambient temperature of 0 to 40°C. Never charge the
RoX 10.0 gps if the crossed-out battery icon is shown on the display. let the
device cool down first!
2.3 Initial use
1. press and hold the
ENTER
button for five seconds.
2. press
ENTER
to change the language.
3. Now press the and buttons to select your desired language then
press
ENTER
.
4. Configure the remaining settings using the same principle.
2.4 Pairing the sensors with the ROX 10.0 GPS
To use the sensors, these must be paired with the RoX 10.0 gps.
Information on how to pair the sensors can be founding under ‘ANT+ pairing’ in
section ‘‘10.3 bike 1–3 & totals’’.