Sper Scientific 850024 Hot Wire Anemometer SD Card Logger - Manual (Page 14)

14
MEASUREMENT PROCEDURES
Turning the Unit On/Off
1. Press POWER to turn the meter on.
2. Press and hold POWER for 2 seconds to turn
the meter off.
Selecting the Function
1. Press and hold FUNC to cycle through the options
listed below. Release FUNC when you reach the
desired function.
Note…
The meter will default to the last function setting used when
it is turned off and on again.
Selecting the Air Velocity Unit
1. To select the air velocity unit, press and hold UNIT.
The meter will cycle through m/S, Km/h, mph, Knot,
FPM in sequence.
2. Release UNIT when the desired unit appears
on the LCD.
Note…
To change the temperature unit, see page 12.
 Air velocity/temperature: “An” appears on the LCD.
 Type K/J thermometer: “tP” appears on the LCD.