Sper Scientific 850024 Hot Wire Anemometer SD Card Logger - Manual (Page 20)

20
DATALOGGER
Note…
To enable/disable the touch-tone feature see page 12.
Manual Datalogging
1. Set the sampling time to 0 seconds (see page 13).
2. Press REC. “REC will appear on the LCD.
3. Press LOGGER. “REC” will flash on the LCD and the
alarm will sound while the measurement data and time
information are saved to memory. The position (location)
number will appear on the bottom of the LCD and will
also be recorded on the SD card.
Note…
To enable/disable the touch-tone feature see page 12.
To change the position number, press ▼. The position
number will flash on the LCD. Press ▲ or ▼ to set the
position number (from 1 to 99). To indicate the position
location, P x (x = 1 to 99) will appear on the lower display.
After selecting the position number, press ENTER
to confirm.
4. To finish datalogging, press REC for longer than
2 seconds. “REC” will disappear from the LCD to
indicate that datalogging has ended.