Flaming River C-10 Chevy Truck Rack and Pinion 1973-87 - Manual (Page 12)

Universal Joint System con’t
3) We recommend the use of ¾” wood dowel rod to mock up the steering shaft to obtain the correct length of the shafts.
4) Install your shaft kit and snug each set screw so that it will leave a mark in the shafts.
5) Remove shaft and dimple each setscrew mark using a ¼” drill bit. (As shown below.)
6) Re-install the shafts using red loc-tite thread locker on the set screw threads. Tighten each setscrew to 25 ft. lbs. Tighten
all lock nuts securely. We recommend that you Inspect setscrews periodically for tightness.
7) Re-tighten the set screw that was loosened in the rack mounting blocks in step #1.
73-87 C-10 Truck
Power Steering Rack and Pinion Cradle Kit
04/22/10
11