GReddy TURBO KITS: Scion FR-S 2013-14 / Subaru BRZ - Manual (Page 12)

―１０―
(3) Install the Turbo Mounting Bracket A. Using the
Turbo Bracket to Pulley Spacers A & B, 。
※ Turbo Bracket to Pulley Spacers A has a lip, be
sure that this lip is inserted into the Idler Pulley.
※ When installing the Turbo Mounting Bracket, be
sure to not remove the serpentine belt.
Pulley Bolt Torque Specs ３６Nm（３．６７㎏ｆ
-m）
〈Parts №４５，４７，４８，６８〉
(4) Verify that the serpentine belt is seated on each
pulley, from then on release the tensioner pulley.
(5) Install the Turbo assembly, and install the turbine
inlet gasket.
〈Parts №１，３５，６４，６５〉
３－７ Three Way Oil Fitting
(1) Install 1/8PT- 1/8PT Straight Union into the
Three Way Fitting as shown in the diagram.
※ Be sure to use thread seal.
※ Too much thread seal or an excess may lead
to oil feed blockage.
※ Be sure not to over tighten the straight union
fitting 。
№64 M8
Nut
№63 M8×35 Bolt &
Nut
№34
№15
№14
№68 M10×
50
№45
№68 M10×
50
№47 Spacer A
№48 Spacer
B