GReddy TURBO KITS: Nissan 350Z 2003-04 / twin TD05-18G - Manual (Page 16)

Brake Check Valve Installation
Install the provided check valve as shown.
(Part Used #39, 46)
Injectors Installation
1. Remove the upper intake manifold collector, fuel rail assembly with injectors and
regulator.
2. Grind the top of the fuel rail as shown to clear the intake manifold.
Make sure not to grind too much. Grind the part on the bracket that is raised down flat.
Clean the rail thoroughly after grinding.
3. Install the 440cc injectors and reinstall the fuel rail using the provided spacer.
(Part Used #65)
4. Cut the factory injector connectors and solder in the provided connector harness.
Completely)
(Make sure to solder
④ Tape up the soldered area ③ Solder the wires
② Twist the end together ① Strip the end of wires
How to solder