Posey Sitter Elite® - Manual (Page 11)


Sitter Elite 11
Setting Alarm Tone
The Sitter Elite has five (5) available tones. This allows you to differentiate between patients
and other equipment alarms.
To Select Tone:
1. Lift the programming control
protective cover (fig. 7).
2. Ensure alarm is on and either sensor
pad, chair belt sensor, or magnet is
attached to alarm. Ensure pressure
is on sensor pad, chair belt sensor
is connected, or magnet is on face
plate (green LED flashes above mode
selection, yellow LED flashes if mode
is set to “Mute” (fig. 9).
3. Alarm mode must be set to either
“Voice and Tone” or “Tone” (see pages
9-10) in order to hear the selection.
4. Press TONE button on left side of
alarm to scroll through the tone
selections (fig. 8).
5. Each time you press the button, tone
will change and a two (2) second
sample plays. The last sample heard
is the tone utilized for the alarm when
the sensor is activated or the magnet is removed
from the face plate, depending on which monitoring
mode is selected.
6. Replace the programming control protective cover,
securing it into place.
H O L D / S U S P E N D
®
Sitter
™
MODE
LED
Fig. 9
TONE
Fig. 7
TONE
0
1
2
Fig. 8