Posey Sitter Elite® - Manual (Page 33)


Sitter Elite 33
Alarm Cleaning, Storage and Battery Maintenance
Cleaning
Sensor, Cables and Alarm Housing (exterior ONLY)
Dampen (but DO NOT soak) a clean cloth with disinfectant. Use extra care to clean sensor cord
plugs. To reduce the risk of damage,
NEVER:
• Use any cleaning substance that contains Phenol;
• Immerse in liquid; or
• Sterilize with heat.
Use a clean, DRY cloth to dry all parts.
Storage
• This device is designed for use in normal indoor environments.
• This device may be stored in ambient warehouse temperatures at normal humidity levels (10
to 50%). Avoid excess moisture or high humidity that may damage product materials (greater
than 90%).
• Store pad sensors flat or hang in a dry secure environment. DO NOT fold or roll sensors, as it
may damage internal electronic parts and cause a malfunction.
For instructions on how to store your Sitter Elite alarm while maintaining custom settings, see
page 8.
Disposal
Dispose of per facility policy. Be sure to follow all laws that apply.
General Cleaning
1. For general cleaning, a soft cloth or cotton swabs are best.
2. DO NOT use sprays or liquids that may damage battery contacts.
3. Tilt case DOWN and use liquid cleaners sparingly. Make sure liquid does not get into main
section of alarm case.
4. Make sure compartment is completely dry before inserting fresh batteries.
Battery Compartment
Battery Leakage. If there is ANY evidence of battery leakage, remove the
alarm from use and notify the appropriate facility authority. The alarm should be disposed
of according to your facility disposal requirements. DO NOT use the alarm and DO NOT
attempt to clean it if there are any signs of battery leakage such as corrosion, rust or
white powder residue.
DO NOT allow batteries to deplete while in the alarm. Change batteries
immediately when hearing the low battery “chirp.” Depleted batteries may leak and corrode,
causing damage to the electronics and reliability. When storing the alarm for a short period
with power “on” to maintain custom voice messages and settings, check the alarm every
week to make sure the batteries are still operable and the alarm is still on. If the alarm low
battery alert is chirping, or the alarm does not power up, the batteries are depleted and
must be removed. DO NOT leave depleted (“dead”) batteries in the alarm to avoid corrosion.
Remove batteries when storing the alarm for an extended period to prevent depleting the
batteries and potential corrosion.