Vaisala HMT360N - Manual (Page 58)

User's Guide ______________________________________________________________________
56 __________________________________________________________________ M210744EN-C
Output Commands
ITEST Testing Analog Outputs
Syntax: ITEST aa.aaa bb.bbb<cr>
This command outputs the current value of each channel and the
corresponding control signal of the digital-to-analog converter.
Example:
>itest 8 12<cr>
8.00000 403 12.00000 7DF
>itest<cr>
7.00150 30A 11.35429 73E
>
The set current values remain valid until you issue the command ITEST
without readings or reset the transmitter. With this command the desired
outputs of the transmitter are shown.
NOTE Before giving command ITEST, reset the transmitter with command
RESET, see section
RESET Transmitter Reset on page 59 .
where
aa.aaa = Current value to be set for Ch 1 (mA)
bb.bbb = Current value to be set for Ch 2 (mA)
NOTE When outputting low currents from Ch 1, remember to remove
RS232C-cable while reading the current output, because of the
increased current consumption for using RS port.