Removing the electronics unit, Figure 23 – Vaisala HMT360N User Manual
Page 66
User's Guide ______________________________________________________________________
64 __________________________________________________________________ M210744EN-C
Removing the Electronics Unit
0605-051
Figure 23
Detaching the Electronics Unit with Probe for
Calibration and Adjustment
1.
Unfasten the screws and open the cover.
2.
Switch the transmitter off with the ON/OFF switch.
3.
Disconnect the flat cable by lifting it carefully, for example with a
screwdriver.
4.
Remove the two screws holding the hinge support. Remove the
hinge support.
5.
Turn the electronics unit slightly upwards to release it from the
hinges. Leave the transmitter base with the cable connections on
place. When putting the electronics unit back to place, attach the
upper hinge first. Remember to attach the hinge support.