High Country Tek emc-3L - Manual (Page 18)

2 Software
2.1 System Requirements
Windows XP, Windows 7 Home Premium, Windows 7 Professional, and Windows Ultimate, (32 or 64bit)
40 megabytes of disk space to support a complete system install
PC with Serial Port - RS232 or USB port
For USB ports you need a USB to RS232 converter (i.e. Dongle)
1
DVC710 controller module
DVC10 serial cable
2.2 Installation
When you install the DVC development software following the steps outlined here you will have one
Programming Tool and one Program Loader Monitor that will support the DVC710.
To install the DVC development software, close all program applications. Insert the DVC Software CD in the
CD-ROM drive, and wait for the installer program to execute. The installer will guide you through the installation
procedure.
NOTE: Install any third party software i.e. USB to RS232 adaptor drivers before installing cables and hardware.
DVC Intella Programming Tool
2.3 Software Overview
The DVC software package includes two applications n
"Programming Tool" and "Program Loader Monitor". These
applications provide the means to configure, design, create,
load, and monitor the user application. The Program
tool is used to configure the inputs and outputs and prog
the control logic for an application. The Program Loader
Monitor is used to download the user application program
files to the DVC710. It also performs real time monitoring o
your system inputs/outputs. Also, you can modify some
input/output configuration settings (i.e. like analog ramp
rates). Another feature of the Program Loader Monitor is it
allows you to see and change EEmem variable settings. For
example, this is a convenient way to have the user interact
with the system to change a maximum pressure setti
input a customer job number as the system is running.
amed
ming
ram
f
ng or
1
A list of HCT recommended USB to RS232 adaptors may be found at, http://www.highcountrytek.com/rs232_to_usb_adapters.htm
P/N: 021-00163, Rev. A.0 - for V5.2 Tools Page | 18