High Country Tek emc-3L - Manual (Page 58)

Next, load and execute the compiled
Hello program. Execute the Program
Loader Monitor program by double
clicking on the Program Loader Monitor
icon in the c:\Program Files\HCT
Products folder.
Now execute the following steps.
Double click on the DVC710 Master
Button.
Double click the Program Load button in
the DVC710 window. The Program
Loader window will open. Cycle power
to the DVC710 this will initiate the
download process.
Select the blue Load Application button.
Using the file locator window navigate to
the project application program and
select and download the file hello.PGM
in C:\ProgramData\HCT Products\Intella
700\Programs\hello.DVC. After a few
seconds and when prompted cycle the
DVC710 power again. This will cause the application program to execute.
DVC710 Program Loader Monitor, Program Loader
Your DVC should now have a continually flashing code of “2, 5” followed by a code of “3, 6” from the Status LED
on the DVC710.
You have successfully completed your first DVC application program.
5.3 Elapsed time Display
This example is designed to operate with only a DVC710
connected to your computer using the DVC RS232 cable and a
+12 volt dc 1.0 amp power source. The DVC RS232 serial
cable is used to load your application into the DVC controller’s
memory from your PC and read data from the DVC for the
Virtual Display.
This example builds introduces you to 4 new programming
concepts namely:
• Logic sequences consisting of Bubbles and Transitions
• Variable
Initialization
• Virtual Display configuration and use
The Elapsed Time program is designed to continually display
Elapsed time from Power Up or a Reset Clock Input (from Dig_1) on the Virtual Display.
The Virtual Display is a Program Loader Monitor facility of the DVC710 that enables you to display application
information as your program executes.
Now you will be guided through the programming of the Elapsed Time Clock. Open the Programming Tool and
proceed.
Intella Programming Tool, Elapsed Time
Application
P/N: 021-00163, Rev. A.0 - for V5.2 Tools Page | 58