Program loader monitor, 1 introduction, Connecting to the dvc710 – High Country Tek emc-3L User Manual
Page 79: 3 starting the program loader monitor, Introduction, Starting the program loader monitor, 7 program loader monitor
7 Program Loader Monitor
7.1 Introduction
The Program Loader Monitor is used to download programs to the DVC710 and to display information from all of
the DVC modules connected together via the CAN Bus. It runs on your Windows PC and uses a RS232 cable
to communicate with the DVC710. Data from DVC expansion modules (i.e. DVC21, DVC70 etc.) is transmitted
through the DVC710 to the Program Loader Monitor. Program Loader Monitors specific to an expansion
module are provided and are used to examine or change the module’s MAC ID and CAN Bus baud rate.
7.2 Connecting to the DVC710
Locate an open serial communications port on your Windows XP PC. Plug one
end of the DVC RS232 serial cable into the serial port (i.e. COM1, COM2, COM3,
etc.) on the computer. Plug the other end into the DVC710 serial cable weather
pak connector on the DVC710 module.
Note: If the RS232 serial cable is connected and the Program Loader Monitor
program is not running, the DVC710 will enter programming mode on power up.
The MS and NS lights on the controller will alternate flashing green. To exit
programming mode start the Program Loader Monitor program and power up the
DVC710 or disconnect the RS232 cable, and then cycle power on the DVC710.
7.3 Starting the Program Loader Monitor
From Windows press the “Start” button and then select the file
All Programs\HCT Products\Intella 700\PLM5.2
The first time you execute the Program Loader Monitor the following screen
appears. Select the PC COMM port to which your RS232 cable is attached.
P/N: 021-00163, Rev. A.0 - for V5.2 Tools
Page | 79