Videoswitch Vi600 - Manual (Page 10)

Digital Recorder
3
1.2 Connecting Up Vi600
For a standard digital recording system you will need
The Vi600 recorder
Some cameras
A video monitor (with S-video or BNC composite video input).
BNC cables
MAINS
POWER
INPUT
MICROPHONE
INPUT
LINE
INPUT
LINE
OUTPUT
CAMERA
INPUT 16
CAMERA
LOOPTHROUGHS
1-16
CAMERA
INPUT 1
SPOT
MONITOR
LOOP TO MAIN
KEYBOARD OF
NEXT UNIT
IBM
KEYBOARD
NOT
USED
SPOT
KEYBOARD 2
TILL INPUTS
MAIN
KEYBOARD
SPOT
KEYBOARD 1
ETHERNET
RELAYS/DOMES
ALARM
INPUTS
ISDN/PSTN
RS232 PORT
MAIN
MONITOR
(BNC)
LOOP TO SPOT
KEYBOARDS OF
NEXT UNIT
MAIN
MONITOR
(S-VIDEO)
GPS
RECEIVER
MICROPHONE
LINE IN
LINE OUT
Connect the monitor output (MAIN) of the Vi600 to a Video Monitor using a BNC or S-
Video cable (supplied).
Make sure that the monitor termination is switched on (i.e. to 75 Ohms)
Connect a camera to Camera Input 1 on the Vi600 using a BNC cable
Connect further cameras to Inputs 2,3,4 etc
Make sure that the voltage select switch is set to suit the mains supply. The setting
required in UK and Europe is normally 230Vac.
Connect the mains power using the mains cable provided