Videoswitch Vi600 - Manual (Page 57)

Digital Recorder
50
11 Technical Data
11.1 Power-On Reset
If you wish to perform a power-on-reset to restore all settings to their factory defaults, press
the
DEF key while you apply power, and keep pressing it until the Vi400/Vi600 has powered
up and displays
FACTORY RESET. Note that this process will reset all user settings,
including camera titles. The
DEF key will need to be pressed for about 10 seconds.
The factory configuration can also be recalled via the menu (see section 9.6.10).
11.2 Accessories Included
Vi400/Vi600
Mains Cable
Vi-X2 Alarm Break-out module
Vi-X3 Relay Break-out Module
Hard Drive Key
Manual
CAT5 Ethernet Cable
Blank CDs (2)
11.3 Changing the Hard Drive
Hard drives are sensitive mechanical devices that may be damaged by shock or vibration.
Always protect them from shock and vibration when transporting.
Remove power from the Vi400/Vi600 before removing the hard drive. Wait for 30 seconds
for the drive to stop spinning before moving the Vi400/Vi600 or removing the hard drive.
Moving a drive that is still spinning can damage it.
The hard drive drawers require a special key to unlock them. This is supplied with the
Vi400/Vi600. Insert the key, and turn it clockwise to unlock the drive.
To put a hard drive back into the Vi400/Vi600, make sure that the lock in the drive drawer is
in the unlocked position. Carefully slide the drawer in as far as it can go with the handle in
the up position. Carefully push the handle down such that the drawer is pulled into the drive
bay. When it is properly located, lock the drawer by turning the key counter-clockwise.
After changing a drive, re-apply power to the Vi400/Vi600.