Videoswitch Vi600 - Manual (Page 9)

Digital Recorder
2
1.1 Connecting Up Vi400
For a standard digital recording system you will need
The Vi400 recorder
Some cameras with lenses
A video monitor (with S-video or BNC composite video input).
BNC cables
ETHERNET
RELAYS/DOMES
ALARM
INPUTS
ISDN/PSTN
RS232 PORT
MAINS
VOLTAGE
SELECTOR
MAINS
POWER
INPUT
MICROPHONE
INPUT
LINE
INPUT
LINE
OUTPUT
CAMERA
INPUT 16
CAMERA
INPUT 1
SPOT
MONITOR
MAIN
MONITOR
(BNC)
LOOP TO MAIN
KEYBOARD OF
NEXT UNIT
LOOP TO
SPOTKEYBOARD
OF NEXT UNIT
MAIN
MONITOR
(S-VIDEO)
IBM
KEYBOARD
GPS
RECEIVER
NOT
USED
NOT
USED
NOT
USED
MAIN
KEYBOARD
SPOT
KEYBOARD
Connect the monitor output (MAIN) of the Vi400 to a Video Monitor using a BNC or S-
Video cable (supplied).
Make sure that the monitor termination is switched on (i.e. to 75 Ohms)
Connect a camera to Camera Input 1 on the Vi400 using a BNC cable
Connect further cameras to Inputs 2,3,4 etc
Make sure that the voltage select switch is set to suit the mains supply. The setting
required in UK and Europe is normally 230Vac.
Connect the mains power using the mains cable provided