Videoswitch CMOR D2 Dome - Manual (Page 4)

CMOR Dome
Videoswitch Page 1 Vc601i.doc
1 Configuring the Dome
1.1 CMOR Evolution Configuration
1.1.1 Auto-Protocol and Auto-Baud
No DIP switch configuration is necessary if the DIP switches are left in their default
configuration (all switches OFF except for 6-way DIP switches section 6 ON). Some
Evolution domes do not have switches fitted.
The CMOR Evolution will automatically detect the protocol and the baud rate. Currently
supported protocols are:
• Videoswitch VXP-4 (RS485)
• Pelco-D
(RS485)
• Pelco-P
(RS485)
• Vista
(RS485)
• BBV
up-the-coax
Supported baud rates are:
• 2400
• 4800
• 9600
1.1.2 Address
The CMOR Evolution will initially respond to all addresses. If there is more than one dome
on the same controller an address for each one must be programmed via its menu. Note
that if several domes are connected they will all respond to commands until their individual
addresses are set.
To set an address via the menu:
1. Select the camera (dome) you wish to configure on the DVR or other controller
2. Enter the dome menu (SET Preset 95 for Pelco)
3. Move joystick Right to log-in menu
4. Enter displayed serial number as password using Up/Down/Left/Right
5. Left to exit menu
6. Down, then Right to enter the Address menu
7. Up/Down to set the address to the displayed address of the controller
8. Left to exit
If the address of a dome has been set and needs changing, you either need to talk to it
using the correct camera address so you can enter the menu and change it as describe
above, or you need to reset the dome address as describe in the next section.
1.1.3 Reset Address
Issue five SET Preset 90 commands in succession, not more than 5 seconds apart. This
will reset the dome address of all connected domes.