Kenwood TM-D710GA - Manual (Page 36)

GPS – 3
TRACK LOG
All movement is saved in the GPS Logger ( Internal GPS only) .
Saved information includes latitude, longitude, altitude, travel
direction, speed, time, and date. The log can retain up to 5000
points of data.
Press [LOG] to turn the Track Log function On or Off.
When turning the Track Log function On, “LOG START” appears
for approximately 5 seconds, followed by the “
” icon.
• When turning the Track Log function Off, “LOG STOP” appears on
the display for approximately 5 seconds.
• With the Track Log function On, even if the power source is turned
Off during a Log acquisition, the log is backed up so that when the
power is turned back on, the log acquisition resumes.
• You can verify the Log activity ratio in the GPS pinpointing screen.
Note:
◆ When the Track Log is turned On while the GPS is Off, the GPS will also
turn On.
◆ When the GPS is not pinpointing, data is not saved to the log.
◆ You can read the Track Log using the MCP-6A.
◆ If the Track Log overwriting confi guration is turned Off (see below), “LOG
FULL” appears when the log memory is full.
◆ When the APRS is On, Log operation will begin only when the APRS menu
COM terminal input is Off.
■ Track Log All Clear
1 Press [ALLCLR].
• “CLEAR ALL?” appears. Press the Tuning Control to clear all
Track Logs.
■ Overwriting the Track Log
When the Track Log becomes full, new data will begin
overwriting the oldest Track Log data.
1 Enter Menu mode and access Menu 502.
2 Select “ON” or “OFF”.
• Selecting “ON” will allow old data to be overwritten with new
data.
LOG SETUP
Enter Menu mode and access Menu 503.
■ Record Method <RECORD METHOD>
You can set the conditions for saving Track information as
GPS Logger.
You can change the settings for travel speed, etc.
Select “TIME”, “DISTANCE”, or “BEACON” for the Record
Method.
■ Interval Time <INTERVAL>
Select an Interval time from 2 ~ 1800 seconds (in steps of 1
second).
• The Interval setting is available only if the Record Method has
been set to “TIME”.
■ Distance <DISTANCE>
Select a Distance from 0.01 ~ 9.99 (in steps of 0.01).
• The Distance setting is available only if the Record Method has
been set to “DISTANCE”.
• The units used for Distance can be set to miles (mi), kilometers
(km), or nautical miles (nm).
Interval and Log Total Time:
Point
Qty
Interval time (seconds)
2 5 10 15 30 1800
5000
166.7 416.7 833.3 1250 2500
150000
(min)
2.8 6.9 13.9 20.8 41.7
2500
(hour)
Interval and Total Distance:
Point
Qty
Interval distance (km)
0.01 0.10 2.00 4.00 6.00 8.00 9.99
5000 50 500 10000 20000 30000 40000
49950
(km)