Gps – 4 target point, Mark waypoint – Kenwood TM-D710GA User Manual
Page 37
GPS – 4
TARGET POINT
You can register positional information for a target point.
1 Enter Menu mode and access Menu 504.
2 Select a Target Point (from 1 ~ 5).
3 Press
[USE].
•
The “in use” target point mark (
) appears to the left of the
channel number.
4 Enter a Target Point name (up to 9 characters).
5 Enter the north/south latitude.
<Menu 627 (DISPLAY UNIT 2 - POSITION): “dd°mm.mm' ”>
<Menu 627 (DISPLAY UNIT 2 - POSITION): “dd°mm'ss.s" ”>
6 Enter the east/west longitude.
<Menu 627 (DISPLAY UNIT 2 - POSITION): “dd°mm.mm' ”>
<Menu 627 (DISPLAY UNIT 2 - POSITION): “dd°mm'ss.s" ”>
MARK WAYPOINT
You can register up to 100 points with the location’s latitude,
longitude, altitude, time, name, and icon. You can edit names
and icons manually.
1 Press
[MARK] (1s) to enter Mark Waypoint registration mode.
•
When registering a Mark Waypoint, the following display appears
for approximately 10 seconds.
2 Press
[EDIT] to enter Mark Waypoint editing mode.
3 Enter a Mark Waypoint name (up to 9 characters).
4 Select an APRS icon. Refer to the APRS explanation
regarding the available icons.
Note:
◆ Even when the Log function is OFF, you can register a Mark Waypoint.
◆ The MCP-6A can read Mark Waypoints.