Night Guard Home Surveillance System C3-RS-900LCD User Manual

Page 24

Advertising
background image

24

3-hour timer start with Temperature-control OFF: This feature is designed
for an extreme cold climate usage. The system will auto start the vehicle every
3 hours, to prevent engine from freezing.

A MAXIMUM OF SIX CYCLES CAN OCCUR.

3-hours timer start with Temperature-control:
If the temperature Sensor is active, the system can be programmed to
automatically start the vehicle’s engine whenever the temperature inside the
vehicle reaches or drops below the preprogrammed temperature level. The
system will monitor the air temperature every 3 hours and will only start the
engine during extreme cold temperatures. There are three temperature levels
to choose from. (OFF, 0 Deg F or –15 Deg F)
Daily Timer Start: The feature is very useful for the driver who wants to run
the vehicle punctually at the same time the next morning. Before set-up of the
“Daily Timer Start”, you should set you time for engine start.

Timer / Temperature Start Operation:

1. Turn the ignition key ON then OFF.
2. Within 15 seconds, Press the

button first,

within 3 seconds press the

button.

3. The parking lights will flash and the siren will chirp

3 times indicating the timed start mode is
activated.

Your set the timer icon or the temperature icon for
engine start flashes for approx. 3 seconds on the
LCD screen. After 3 seconds the

icon stays

displayed on the LCD screen

Timer Start

Temperature Start


Daily Timer Start Operation: The feature is very useful for the driver
who wants to run the vehicle punctually at the same time next morning.
Before use of the “Daily Timer Start”, you should set the start time for
the engine.

Daily Timer Start:

Turn the ignition key ON then OFF. Within 15 seconds

press the

transmitters

button then within 3 seconds press and hold the

button for three seconds. The parking lights will flash and the
siren will chirp (6) times. The vehicle is now programmed to start
at the same time the next day. Your set time for the next day
engine start flashes for approx. 3 seconds on the LCD screen.

After 3 seconds the

icon stays displayed on the LCD screen.

4. Press the brake pedal to stop the vehicle’s engine.

Exit the timer start: Timer start can be exited manually as follows:

1. Make sure the remote start system is not operating the engine.

2. Turn the ignition on. The LED and parking lights will flash (4) times. The horn
chirps (4) times.




Advertising