Adjusting the detail of audio control, Audio setup – Kenwood KDC-BT6544U User Manual
Page 21
English
|
21
Function of KDC-BT6044/BT6144/W5544U/W5644U
Adjusting the detail of Audio Control
You can adjust the following Basic Audio Items in
datail: Bass level, Middle level, and Treble leval.
Bass level
Adjustment Item
Display
Range
Bass Center Frequency
“BASS F”
40/50/60/70/80/100/
120/150 Hz
Bass Q Factor
“BASS Q”
1.00/1.25/1.50/2.00
Bass Extend
“BASS EXT”
OFF/ON
Middle level
Adjustment Item
Display
Range
Middle Center Frequency “MID F”
0.5/1.0/1.5/2.0 kHz
Middle Q Factor
“MID Q”
1.0/2.0
Treble level
Adjustment Item
Display
Range
Treble Center Frequency “TRE F”
10.0/12.5/15.0/17.5 kHz
1
Select the Basic Audio item
For how to select Basic Audio items, see <Audio
Control> (page 20).
2
Enter Detail adjustment mode of Audio
Control
Press the [AUD] knob for at least 1 second.
3
Select the Detail Audio item to adjust
Press the [AUD] knob.
4
Adjust the Detail Audio item
Turn the [AUD] knob.
5
Exit the Detail Audio Control mode
Press the [AUD] knob for at least 1 second.
⁄
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime by
pressing any button except for [AUD] knob or
[
0]
button.
Audio Setup
You can set Sound system , such as follows;
Adjustment Item
Display
Range
Front High Pass Filter* “HPF” F
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter* “HPF R”
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter*
“LPF SW”
50/60/80/100/120/ Through
Hz
Subwoofer Phase*
“SW PHASE”
Reverse (180°)/ Normal (0°)
Volume offset
“V-OFFSET”
–8 — ±0 (AUX: -8— +8)
Dual Zone System
“2ZONE”
OFF/ON
*Function of KDC-BT6044/BT6144/W5544U/W5644U.
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “ZONE2” of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 20) or [
5]/[∞] button on the remote control
(page 33).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
B64-4317-00_00_E_English.indd 21
08.11.1 3:47:59 PM